Linkbox

Fergiefarming87 · Post by **Fergiefarming87** » Mon Jun 20, 2022 9:50 pm

After rescuing my linkbox earlier this year from its resting place I have decided to make this my next project, now I have finally set up a workshop at home. It's not in too bad a condition with rot in the usual places in the corners. Now I have a few places where the rust has not eaten all the way through and I was wondering if brazing the metal here may be a good option. I haven't had a go at this before so wondered if anyone out there with a similar project had used this technique to fill holes and firm up the existing structure. Any ideas welcomed