Hello,
Does anyone have any knowledge of where to get new pushrods for a diesel Ferguson TEF20, we only require one as it is the only one that is bent and the rest are fine.
Thanks.
Ferguson TEF20 pushrods
Re: Ferguson TEF20 pushrods
Hi.
Have you tried to straighten it, if the bend is in the middle of the push rod put it longways in a vice and take the worst of the bend out, then do the rest with a hammer. If the bend is nearer the cup end you may have to use a little bit of heat, do not over heat. Have you found the problem that caused the pushrod to bend?.
Have you tried to straighten it, if the bend is in the middle of the push rod put it longways in a vice and take the worst of the bend out, then do the rest with a hammer. If the bend is nearer the cup end you may have to use a little bit of heat, do not over heat. Have you found the problem that caused the pushrod to bend?.
-
Roadknight
- Posts: 22
- Joined: Sun Jun 23, 2024 4:26 pm
Re: Ferguson TEF20 pushrods
We have now managed to source a used pushrod, the problem was one of the inlet valves sticking in place and when we removed it it was signigicantly harder than the rest and needed a blow with a hammer before being able to shift it. We beleive this was caused by a build up of carbon deposits on the stem of the valve.