Ferguson Club Information Exchange

Hi If the leads are copper wire type the end of the wire should go through the little washers and be spread out. Another way to test how good the spark is, is to put the coil lead into the coil and place the other end near the block then open and close the points and you should have a good spark at ...

Hi Ben
There are down swept exhaust kits available from parts suppliers that include the parts that you require, gasket, down pipe, silencer, and bracket. You will have to remove the bend that`s held with the 2 bolts and the new part will bolt on there going down the way.

Hi Alwyn. The tractor would originally be positive earth, may have been changed to negative earth it`s just a case of polarizing the dynamo to suite the earth type. Start the tractor on petrol then change to TVO, you require a licence to buy or mix TVO. You should be able to get a bulb form any part...

Morning
If your tractor is a FE 35 TVO with a 4 cylinder engine, it should have a rev counter drive connection just under the distributor or built into the bottom of the distributor. if you require parts, it will be a case of looking on the internet.
Sandy.

Morning Richard

The spring in the picture is the type required, if its not holding the throttle try a stronger spring and maybe a bit longer. If the cork disc that works as a throttle brake has gone hard it may be that that`s not holding the throttle at the set position.

Regards
Sandy.

Hi The only information the I can see for a 221 or 746 Rigid tine cultivator is a parts book on eBay.com. Is the Covington TP 46 a fertilizer attachment for inter row placement of fertilizer, where it makes 2 or 3 rows of fertilizer in the ground for the seed to be planted into. Are you in North Ame...

Hi Mike
Please find some information attached. Sorry for the delay.
Regards
Sandy.

Hi Michael

The small Massey Ferguson balers that may be out there, are a MF 703 or MF 15./20.

Sandy

Hi Michael Trying to bale with a small tractor with a single clutch is quite difficult, if you come to a lump or thick bit you require enough power to get through it you cant dip the clutch to slow down. 35 / 23C. single clutch serial number should start. S.D.F. 35 / 23C. dual clutch serial number s...

Hi Andy
With the 2 nuts that hold the injector in place, undone about 2 turns try turning the engine over with the starter, this may pop the injector loose. The other way is with 2 pry bars, one each side of the injector trying to lever it out.