Search found 28 matches
- Tue Apr 23, 2024 1:02 pm
- Forum: Ferguson T20
- Topic: Ignition Issues
- Replies: 2
- Views: 156
Re: Ignition Issues
Hi If the leads are copper wire type the end of the wire should go through the little washers and be spread out. Another way to test how good the spark is, is to put the coil lead into the coil and place the other end near the block then open and close the points and you should have a good spark at ...
- Thu Apr 18, 2024 9:43 pm
- Forum: Ferguson T20
- Topic: Exhaust conversion
- Replies: 1
- Views: 138
Re: Exhaust conversion
Hi Ben
There are down swept exhaust kits available from parts suppliers that include the parts that you require, gasket, down pipe, silencer, and bracket. You will have to remove the bend that`s held with the 2 bolts and the new part will bolt on there going down the way.
There are down swept exhaust kits available from parts suppliers that include the parts that you require, gasket, down pipe, silencer, and bracket. You will have to remove the bend that`s held with the 2 bolts and the new part will bolt on there going down the way.
- Sun Apr 14, 2024 3:46 pm
- Forum: Ferguson T20
- Topic: New to this Fergie Ted 20
- Replies: 1
- Views: 138
Re: New to this Fergie Ted 20
Hi Alwyn. The tractor would originally be positive earth, may have been changed to negative earth it`s just a case of polarizing the dynamo to suite the earth type. Start the tractor on petrol then change to TVO, you require a licence to buy or mix TVO. You should be able to get a bulb form any part...
- Sat Apr 13, 2024 9:13 am
- Forum: 100 series and under
- Topic: 35 4cyl TVO Tacho
- Replies: 1
- Views: 169
Re: 35 4cyl TVO Tacho
Morning
If your tractor is a FE 35 TVO with a 4 cylinder engine, it should have a rev counter drive connection just under the distributor or built into the bottom of the distributor. if you require parts, it will be a case of looking on the internet.
Sandy.
If your tractor is a FE 35 TVO with a 4 cylinder engine, it should have a rev counter drive connection just under the distributor or built into the bottom of the distributor. if you require parts, it will be a case of looking on the internet.
Sandy.
- Wed Apr 10, 2024 10:57 am
- Forum: Ferguson T20
- Topic: Throttle Spring
- Replies: 2
- Views: 154
Re: Throttle Spring
Morning Richard
The spring in the picture is the type required, if its not holding the throttle try a stronger spring and maybe a bit longer. If the cork disc that works as a throttle brake has gone hard it may be that that`s not holding the throttle at the set position.
Regards
Sandy.
The spring in the picture is the type required, if its not holding the throttle try a stronger spring and maybe a bit longer. If the cork disc that works as a throttle brake has gone hard it may be that that`s not holding the throttle at the set position.
Regards
Sandy.
- Mon Mar 11, 2024 1:38 pm
- Forum: 500, 600, 700 Series
- Topic: looking for owners manual PDFs
- Replies: 3
- Views: 240
Re: looking for owners manual PDFs
Hi The only information the I can see for a 221 or 746 Rigid tine cultivator is a parts book on eBay.com. Is the Covington TP 46 a fertilizer attachment for inter row placement of fertilizer, where it makes 2 or 3 rows of fertilizer in the ground for the seed to be planted into. Are you in North Ame...
- Wed Dec 20, 2023 4:56 pm
- Forum: Ferguson T20
- Topic: Wiring a TEf20push button solenoid
- Replies: 4
- Views: 3790
Re: Wiring a TEf20push button solenoid
Hi Mike
Please find some information attached. Sorry for the delay.
Regards
Sandy.
Please find some information attached. Sorry for the delay.
Regards
Sandy.
- Tue Dec 19, 2023 7:10 pm
- Forum: Ferguson T20
- Topic: TED-20/MF35 for square baler?
- Replies: 3
- Views: 2347
Re: TED-20/MF35 for square baler?
Hi Michael
The small Massey Ferguson balers that may be out there, are a MF 703 or MF 15./20.
Sandy
The small Massey Ferguson balers that may be out there, are a MF 703 or MF 15./20.
Sandy
- Fri Dec 15, 2023 10:43 am
- Forum: Ferguson T20
- Topic: TED-20/MF35 for square baler?
- Replies: 3
- Views: 2347
Re: TED-20/MF35 for square baler?
Hi Michael Trying to bale with a small tractor with a single clutch is quite difficult, if you come to a lump or thick bit you require enough power to get through it you cant dip the clutch to slow down. 35 / 23C. single clutch serial number should start. S.D.F. 35 / 23C. dual clutch serial number s...
- Thu Dec 14, 2023 9:46 pm
- Forum: Ferguson T20
- Topic: TEF20 Injector
- Replies: 1
- Views: 1807
Re: TEF20 Injector
Hi Andy
With the 2 nuts that hold the injector in place, undone about 2 turns try turning the engine over with the starter, this may pop the injector loose. The other way is with 2 pry bars, one each side of the injector trying to lever it out.
With the 2 nuts that hold the injector in place, undone about 2 turns try turning the engine over with the starter, this may pop the injector loose. The other way is with 2 pry bars, one each side of the injector trying to lever it out.