Ferguson Club Information Exchange

Yes, we have but we are just a bit worried about it degrading overtime, and not being a proper long term solution to this problem.

Yes, we have but we are just a bit worried about it degrading overtime, and not being a proper long term solution to this problem.

Hi, We have been doing rather a lot of topping with our fergi, and it seems we are getting our fair share of punctures. The problem being the front tyres, where the thorns puncure between the ribs. Has anyone had their tyres professionally foam filled, and would you reccomend it being done? Another ...

We have now managed to source a used pushrod, the problem was one of the inlet valves sticking in place and when we removed it it was signigicantly harder than the rest and needed a blow with a hammer before being able to shift it. We beleive this was caused by a build up of carbon deposits on the s...

Hello,
Does anyone have any knowledge of where to get new pushrods for a diesel Ferguson TEF20, we only require one as it is the only one that is bent and the rest are fine.
Thanks.

Thanks for your reply, we will remove and rebuild the water pump then.
Thanks again.

Hello, We have got a Ferguson TEF 20, and recently we have been using it under more load (hauling logs in a 3 tonne trailer). On our third load, the middle core plug on the engine came out, leading to a loss of all of our coolant. We hammered the plug back in, and put sealent around it. We refilled ...

Hello,
Thanks for this but in the end we managed to pick up an old Lucas PP-G1 three way push pull switch that looks in place on the dashboard.
Thanks.

Hello David Lewis, We have not had it looked at yet, it could be an option to do it ourselves but due to lack of experience on rebuilding engines and engine tools it may be quite hard. It could be an option to rebuild it ourselves though. Did you by any chance use the agriline kit for the rebuild? I...

Hi, I am thinking of fitting a couple of headlights and a rear light to my ferguson TEF-20 and would like some advicce on what swich to use, or whatever would have been the original switch they used back the day. I have a hole in the dash for it to go but just need to know what swhich to use first. ...