Ferguson Club Information Exchange

Hi
I would like some advice/help regarding fitting the seat base to the hydraulic cover.
I have been unable to get studs like the original ones. I would like to know if it is possible to still get them and where from. If not, does anyone know what size they are so that I can use suitable bolts?
Thank you.

Hi

The stud size is 1"3/4 x 7/16, UNC one end and UNF the other. You will also require 2 x 7/16 UNF nuts, UNC end screws into lift top. Have seen them for sale on eBay before.

Sandy.

Thank you very much.

Hi Sandy

Just thought I’d let you know that thanks to your help I ordered the parts from Acorn Services Tractor Parts and they are now here and fitted.
Thank you again.

Hi there guys, bit out of topic but I’ve got a Massey 35 and wanted to put on display for some shows
Only issue is I haven’t got the vin number to do so anyone scrapping any that I could have the vin number off, thank you as well