Ferguson Club Information Exchange

Hello,
I have fitted the ferguson pickup hitch onto the bottom of my Ferguson TEF-20 but both of the orignal stay arms will not fit on the hitch end (where the pin goes through the pickup hitch), as one of the holes is small and doesnt fit either the drawbar or the hitch end and one of the ends fits both. I am confused as how to fit this. Can anyone help me attach the stay arms?
If anyone has any pictures of how they have fitted their stay arms up close, it would be much appreciated.
Thank you.

From memory...
Both hitch bars are identical. Each should have a small hole one end and a large the other. The small end goes to pin through the hook, the large end goes on the T bar, and should fit on the stepped part of the T bar, not the lift pin.
At a guess I'd say the hitch bars you have are actually horizontal stay bars that would fit between the 9 hole drawbar and the pin under the mudguard bracket. At a glance they do look very similar.

Hi,
Thank you, I will look into this.